Shower Backer Boards Ease of Install

Installation Is a Snap

Super-Panel is easy to handle and install and requires just one person for the job.
No special tools or equipment are necessary.

Score and Snap

Using an ordinary carbide-tipped utility knife and a straight edge, score through the panel on one side, then snap board at the score line. Cut mesh on the other side and snap back.


Cut-outs

Cut through the mesh on both sides. Knock out the piece with a hammer. Smooth edges with a rasp or file.

To Fasten

We strongly recommend you use corrosion-resistant cement board screws (available from Bed-Roc) to fasten panels to framing. Fasten screws every 6” to 8” along studs, leaving 1/8” to 3/16” gap at all joints. Perimeter fasteners should be located approximately 1/2” from edge.

Joint Treatment

On all wall joints and corners, fill gaps with mortar and finish with a 2” fiberglass tape over which a thin coat of mortar is then applied.


Bonding Materials

To fill joints and bond tile to Super-Panel, use a latex-modified, thin set mortar, using a notched trowel. We recommend that an acrylic additive be added to the mortar to achieve a stronger bond.
As Super-Panel is unaffected by water but not waterproof, we recommend that any area behind Super-Panel that must be kept totally free of moisture or water should be protected by an impermeable membrane.

Installation Is a Snap

The Right Product for the Job

Whether you’re building or remodelling, avoid the problems of inferior grade boards. You want your project to be a labour of love, most importantly, you want to know your project will be trouble free for many years to come. Experienced Architects, Interior Designers, General Contractors and Renovation Contractors know the problems associated with inferior-grade backer boards. When in contact with moisture and humidity, lower quality backer boards begin deteriorating, rotting, warping, buckling or blistering. As the problems grow, especially in gypsum-based products, you are stuck with expensive repairs.

Ease of Install

The tiles go on - the smooth side or the rough side?

A. Most people prefer the smooth side but they can be installed on both sides.